REDWALL ! REDWALL ! Garage Tool Organization (@MilwaukeeTool PACKOUT Wall with the E-Track )

that this could happen directly, I got to where a standard three-pack stack fits and a little more underneath. I could have run my rails a little more, but when you see here, if I go this high, I can make it. a small

tool

box and the standard profile organizer and I'm out of space. If I go up one more I can only get a standard profile, I can't get one of these are about the height I'd like to go and of course if I go down a little bit more you beat them up so the five foot sections are perfect.

You can see here I'm using my joey to hang my kreg jig, obviously I need it. more Joey, my fuse panel is exposed. I'm going to paint it, but I need to drill. Back up and down for this table saw. I tried something here. I like it, but I don't think I'll go. what to do if I make more I'm just going to make one more up I really wish there was a better way to hang them and I'm probably going to try some of the undefeated trail mounts since I carry my boxes a lot uh If you were using your PVC accessory boxes, You could probably get away with all three printed, it wouldn't be a problem, eh, but I want to put so many in there that I wouldn't want it to be more boxes with just a little bit. space where I can put the box in and take it out, yeah, and then I have the right rollers so this can turn the light, the cart fits.

I'll show you something I've been doing when I was working on my drum

wall

. right, I pulled out my drawer, this is where I put my main hardware that I use a lot and this is like the number one container that I use, that's why there's only two in here. I could probably stack it here, but this is also my normal drill. set, but one thing that's really nice about having the drawers here is that I just do this and you can leave it open and it doesn't fall out. I could have another drawer and put another one in there and I could have my hardware while I work.

I just rested it in the drawer and it worked pretty well. I liked it, so I think I'll continue using it that way. Of course, when I'm not using screws, I can close it and put it back somewhere other than Milwaukee. right option, so you lose so much space for each of these places, so you definitely don't want one per pack because with the hardware they use to lock them and all that, you can't really put something underneath, huh. I have a couple of ideas, but you can. I'd like half of these. I'll tell you because I want to put something in there so I can get some of the brackets and make one.

What else? Yeah, like I said all my rollers I still have another board like I said, I could put it on top of that box, but I want to find a different way, I think this

wall

here, this is the last piece of drywall, so that wall, I think , because you need about four feet for two of these side by side and I don't want to have it here at the door, so probably from this switch there will be packets and from here there will be quick access things. I went ahead and used a stand that says Jake. ball to hold my stealth mount so that's my m18 stealth mount 12 volt stealth mount you can see here the batteries lock it and then it can be attached to pack this pack is my common everyday use this is the one I use in and out of the house mainly inside the house, but I'm trying to get as many packages out of the house for laughs, uh, wife acceptance factor, if you guys don't know, so let me bring them in and I'll show you a a little bit closer, so I was talking about this in the live video, but these stands with the hooks work pretty well.

This one is steel, so my magnetic level tape measure drills through. I have the hidden locking mount for the m12s which I like. keep a battery in them, so I'm going to do something extra, uh, I have to get some spacers, some washers so this doesn't do what it did, that's my switch right now, so you know, super super safe, you will love how you can. I use a wire nut as a switch, this is what I use the most. I install the controller batteries. My supercharger. 12 volt configuration. There are batteries. 12 volt drills that are not the installation driver.

Drill 18. Impact tape measure 18. sequential charger and then the interior and exterior drawers so I have low voltage there, the little bone stacker uh dennis for that. I've been doing a lot of things around the house. I needed anchors for a small truck setup. the drill, so when I pick it up I can leave it there, I went ahead and put a mount here for the vacuum, this is like everyone's favorite vacuum, at least in my family we all love it, so I went ahead and mounted it there . Then I played with some of these Room Industries brackets that I had on the drywall and it was just coming loose, but you can see here that it also works for the Bosch 12 volt because they have a similar design and it definitely works for the milwaukee scooter, so I'm going to equip it a little differently, this is short term, I want to give it some power and then I want to put the chargers in the back and then stack the batteries. front uh yeah I know a couple of people said oh don't put your chemicals in with your batteries well this is what I have so I'll probably buy a metal cabinet and move those packs around.

You can see the supports, uh, wherever I put the plywood that I put down. screws on each side uh and now things are where I assumed they should be uh I have more packages in the house like I said, so I need another wall there, but basically what I'm going to separate is things like screws, hardware, washers, springs, stuff like that uh right now I have some of the electrical stuff together and then above those are really big washers so I shouldn't really say big washers so these are things that I don't use a ton and that's what it's going to be the top obviously I have a problem with the refrigerator.

I don't use nail guns, they are air, I don't use them a ton, I'm going to buy a battery, but they are good nail guns, I'm not going to get rid of them, pack the light, pack the vacuum,

track

saw, I use a lot the fan with something like that next to it, it's that tall, it doesn't seem to fit very well, but it is. sitting there, so I have more spools of wire, more spools, I really want them to be separated, I want to be able to take them out like I was saying, and then some less used material that was heavier than the one I didn't have.

I want to get all the way to the top and then pull out another mobile packet, so in theory once they're out of it, we'll be able to move where I need to, this is my router packet, so normally what I would do is grab something like this and put this at that height, you could put it a little bit higher so you can roll one of these stacks into the middle and route it. I will eventually have a router on this surface but I had a big big barn at the last place and it was much easier so this should go ahead and install the wheels uh or maybe don't install them and maybe just install the wheels on something like that, I don't know, but that needs to go down and restart uh that's temporary until I can organize all the ones that I really want to go through and get rid of everything that I don't need uh so you know I had the uh 35 by 40, so it was like 1300 square feet and then I had a 20 by 20 loft so I had a lot of stuff in the last place and I had to try to get everything I could in here so this thing had most of my mechanical stuff and I plan on keeping it that way, except in Milwaukee.

The battery operated things won't exist there, they'll all stay here, so I'll probably install some drawers so that as I live with this and move it around, it will fit, but basically I need to organize those things now permanently mechanical and then the impacts that are related to headache. I'll have a drawer reserved for them just because the red will go with the red. uh make a couple more wall mounts for things like the Craig jig so they can Climb up there, out of the way, it was a lot of fun. I have some

tool

s for organizing organs.

Now I have to go through and get rid of some things. I just don't have the space. I have like 15,000 plum bobs. and like 10,000 staple guns so it looks like I have three different backpack sprayers so I have to put up some brackets and put things like that on the wall because if you use all the horizontal space you'll get more space so that's what I plan on . What I do is I'm going to get horizontal and I'm going to remove things from the floor. I can walk here now. I have some containers on the front porch.

Some jack stands. I'm going to use some of these things. build a couple of jack stands and stuff like that uh I'm just going to mount the e-

track

right on the concrete block and that's it, why not? It's not going anywhere. It's starting to get a little cold in Florida, so I probably won't turn on the air conditioning, but once I get through all the bands, I'm hoping to have even more floor space. I figured out a way to be able to get into that panel, so now I can power the table saw, so get it running again, uh, because the table saw is 240.

Everything else is 110 and I've been able to get by, so yeah, this project, I would say is a huge success, I mean what more could I ask for? The packages are organized, I can access them now and I don't have to completely remove 15 of them to get to the bottom one, so once I get some more money, I'll make the other wall to get the packages out of the house and that, uh , pack up the happy princess. I appreciate everyone watching. I was going to announce the business card winner, but this video is long enough, so you guys just have to enjoy it for what it was, which was putting it together and taking something from me. my own medicine and organizing my own things I hope you guys watched this whole video uh I'm going to try to post links to more things uh there's a new guy doing this I'll post a link for that yeah I'm going to post a lot of links and if you need me comment below if you have any suggestions comment below if there's anything you think I should do differently comment below or if you just want to throw out the algorithm comment below subscribe I appreciate you all watching and it's time to I'm leaving uh well I'm done doing packing for the day, so have fun, see you, oh yeah, and check this out, subscribe, check that out, subscribe, they're here, here, here, here, there and there, do what Abe says and click on these things because one of these things is amazing, so I have to go see them.

I wanted to add something. You can imagine this is not done sitting down, which means I was on my feet for two days in a row and while on my feet. my feet were in a cloud of unicorn farts and they were just glowing at my worst job use jake of the 10 will save you ten bucks on your first order that's right this is an infomercial so be sure to watch it. I'm going to put a link in the video too uh and now do all that jazz stuff and click on these links and all that fun stuff jacob all 10 10 in front work clothes you guys have a good