Como doblar drywall en un Arco

Hello my friends, welcome back to my channel. I know there are many comments on how to make a round wall and today this little project came out and I would like to show you how to make more than just your bars and we are going to mark the edge of where the wall ends. bow and then with a D here and then with a line here I almost know that my bow ends there and my bow ends here I mark it because when we cut with the raulí the tip goes behind the wood so by boarding them you know where it starts and where you have to start curving follow its voice from below and above I have 56 47 in this case it is more or less square so we are going to cut it and we see how the upper square is in the upper square only Let's see now, putting the blade so we're going to cut it, football, as I told you, you have the mismatch at the top, already setting the time and open to make a mismatch, we have to remove it like here you have without cuts, so it means that we are going to cut it, 5 we are Down here, from five ends to nothing, it has to be less than a quarter open in everything you do because if it doesn't crack, we only have 5, we are there and I'm going to cut from 5 eighths to nothing, including the knife, I remember the same thing in the back.

Remember that here we marked where the arch began here and that is where the arch begins. Usually I did not mark it but keep in mind, I am going to mark it. We are going to cut it as if it were a door, so I am going to start from left to right where it begins. long I'm going to take it out a little bit I'm going to start like this here we have a little more than four feet from so wolf put you up and the whole leaf under we cut the bottom one no no no efe mark the values ​​1 yes the round cut We already have it, we are going to use it great whenever a cut like this one moves, we have to put a support on it so that it can be tied with the one below, and it also moves fourth.

Let's go, look carefully to rap the frame, we are going to have to mark all the bars more or less like this 2 as long as you know where they are that is what counts this we are not always going to do it in a little room below where the two meet we are going to cut them up to here which is a little room below where they have 2 let's to take the first 33 by 6 we are going to cut yes with four feet ah and we are going to cut the first one at thirty-three and a half no i ah why are we always going to do the side where it hits towards the a and just like in these points we are going to take the cut, the manual cut, we are going to start with the next blade with this, one thing you should know is that where you have a factory, it is more difficult for it to bend, so we are always going to try to cut the truth, but at the same time, well We have to know how to work like this.

We are going to cut two sheets. No, in this case, it will take a small piece to cut 2. You just have to add a little water to the back to wet both of them and this is easy. Let's go like this, the edges are always a little bit. more difficult than about but yes it is a 48 it would be easy this bends very easily so I am going to try to fold the edges a little and then the middle ones that's it this one bends very easy so it would be better to force the whole from side to side but They are going to break so that they can fight better, we are going to measure and a half to four feet as I don't want the factory to remain here and then contribute here is 42 and a half he took away so that this side is not manufactured aha and where we already have the penalties The sheet is wet on the back and that's how I'm going to put it, then stick it there and do the folding work.

These fold very easily like this, but be careful, try not to put so much pressure on it too quickly, where space and then listen here on the computer above 2, it's very easy like this. bogado and we are going to start screwed from here to here I have already marked the bars on the wall here from there to here and one by one ah of 15 as I tell you a little room upstairs from where the two touch we assume that it is wet when the We put for the finger, nothing happens if in fact I do it right slowly so we start from above well gonzalo pieres t 45 44 7 ah thank you very much for your comments for watching my videos I hope this helps you like all the ones I make if you have not subscribed Subscribe give me a like and don't forget to share