Samsung Edge Lit 55" LED TV-No Backlights & No Image LED Strip Replacement Models UE55 UA55 UN55

In this video we will show how to replace the LED

strip

s on this 55-inch Samsung LED TV. Start by removing the back cover of the TV. The TV will have these metal cables on the back. You can slide them out to remove them and then before reinstalling them. the back cover, slide it back into place, remove the two brackets on the back of the TV riser and remove the speakers and disconnect the speaker cable from the main board, disconnect the infrared sensor, disconnect the ribbon cables we are installing on some spacers to hold the back of the TV while we work on the front of the TV, then remove the kick plate covers, there is a little bit of tape on the kick plates, just remove them to leave them free, be very careful with the protection plates as they are very fragile, disconnect the bezel by the stops and then turn the TV over and remove the rest of the bezel from the TV lift up the stop plates and tape them to the TV panel using suction cups, lift and very carefully remove the panel from the TV to the layers of diffusion tape in the corners to keep them in the order they came in so it will be easier when you put them back remove the filter frame around the TV be very careful when doing this to do not break it lift and remove the reflector The LED

strip

sheets are at the bottom of this TV.

Disconnect the power cables of the LED strips and then start to remove the LED strip at the corner, then use needle nose pliers to grab it and twist it to remove the LED strips. the bottom of the TV clean any debris left from the LED strips remove the tape from the back of the LED strips slide the LED strips into position and hold them tight to the bottom of the TV place the slots facing up place the notches facing up and make sure to remove the small plastic piece on the connector where the power cord goes, then connect each strip to the power cord, reinstall the reflector sheets, sliding the plastic reflector sheet with the line transparent on top goes on top of the TV reinstall the filter frame around the TV reinstall the diffusion layers make sure they are snug in the corners reinstall the TV panel remove the tape and release the damping plates reinstall the TV bezel around the TV put the damper plates back into position very carefully, then you can slide the small piece of tape on top of them.

Reconnect the ribbon cables. Reinstall the damper plate covers. Reinstall the speakers and reconnect the cable to the main board. Reinstall the infrared sensor. Reinstall the brackets on the back of the TV. the back cover of the tv