How to apply hand tied beaded row hair extensions - Vision Hair Extensions

Hi, I'm Lynn from Vision Hair Extensions. Welcome to my educational video series on

hair

extensions

. In this video I will show you installing

hand

tied

hair

extensions

using my chain. You need a metal spinneret. This

beaded

row application method we show can be used by

hand

.

tied

wefts or machine tied nets tools needed our curved needle weaving thread extra large silicone line beads a looping tool curved nose pliers assorted clips and Bandhu weaving glue used to glue multiple wefts together for thickness today we are using three select

vision

packs hand tied extensions glued with bondo weave to begin parting the hair and measure where you would like your weft to start and end at least two fingers width above the ear clip and mark where the weft ends to so that you can correctly place the front beads.

The front beads should be applied slightly behind where the weft will end. Take a large rectangular section of hair and

apply

the first feed from the base at about a 45-degree angle to the back. We like to use extra large beads so that the most hair can fit. on them forming a firm and secure base avoiding too much tension on the hair for the next bead, take a slightly smaller section of hair along with half of the hair coming out of the previous bead and

apply

the bead as before, the second bead It should be parallel to the first, the third and the following beads can be inclined downwards following the path that started from the plan.

Continue stringing the beads three-quarters of an inch apart until you reach the middle of the head. Repeat this process on the opposite side until you are at the middle clip. Place your weft on the row you made, making sure the West on each side goes slightly past the first few feet, take your knitting thread and measure at least two spans long for each row you don't want to run out of. Thread your curved needle halfway by pulling. the knitting thread halfway so that the thread folds, tie a knot at the end to secure or your first stitch goes up between the first and second beads before pulling the thread all the way, pass the needle through the loop at the end blocking the thread hold the thread towards the head and sew back on the first bead staying under the thread being held repeat this time sewing in front of the first bead make sure the thread does not slip off the end of the weft do this twice followed by a downward stitch coming in at an angle to set the last stitch now as the difficult parts start sewing in the opposite direction along the west, making sure to always sew behind the chained hair or a bead on each stitch. three quarters of an inch apart, this edge is called blanket stitch, the end is the same as the beginning, properly securing the ends down is very important, the first and last stitch should be just in front of the end beads, one Once complete, cut the end of the thread. and pull one rope leaving one behind, not the two ropes together three times, a second and even a third row can be applied directly on top of this row thanks for watching, like this video and subscribe to learn more about extensions of hair, visit us at

vision

hair extensions com for all your hair extension needs