How To Double Loop Lace On Leather

In this segment of our video series I want to show you how to do the

double

loop

stitch for the distance to tie, we are going to need about seven times as much for the amount of

lace

, however, we will show you how to pierce, so we will use pieces of

lace

They measure approximately one yard. Now let's attach our needle. The first thing I want to do is with a very sharp template knife, peel off the tip of my lace and then I'll take the. same knife and I cut it into a point now we are going to load the needle now I take my cord and with my nail and holding the needle I can open it and slide the cord under and then with the analyzer or some other mallet or something we can tighten the needle, it think the problems are with making the

double

loop

, start at one hole first and then leave several inches, bring it over the top like you see me doing here, go through the next hole, pull it up, tight, not too tight.

And notice now as I do this, I go over the top, I roll it, so now I'm going to go over the X that you see there, lift it up and tighten it very tight. Now we go through the next hole. have another X, we go through the X, the X and everything, keep doing this around your project. I've gotten to the corner and what I want to do is go through this corner hole twice, so I'm going to use the stylus and enlarge that hole a little bit and also do that on the next hole, so now I'm going to take my needle and go through that hole like you normally would to adjust it and as always, we go through the cross, we go through that same hole. a second time I always do the cross I pass through the next hole through the cross through that same hole the second time through the cross and we will continue interlacing now it's time to make a splice so I'll pass through now I'm going to Leave this on one side, start with another piece of lace and I'll come down here with about three holes and I'll come from the inside out.

Did you see me doing it here now? I'm going to let that tail come back and I'm going to continue tying and I'm going to tie that tail underneath always through the cross now through this hole I'm going to go between the layers of

leather

I'm going to continue tying now with my other piece of lace and we're just going to continue tying and they put another piece underneath. , we're just ready for the end. Now you'll notice that I've removed a couple of points. Now, after going through the second to last hole, I'll go up the loop, then back through the cross, then down. the loop out and now it's just a matter of taking the cord, now we go through that last hole and we go up between the thicknesses of the

leather

until it goes through the needle and you can put it in like this, you have a real good ending and we will take Cheers or a knife and We will cut and make your legs very flat and uniform.

It's a good idea to hit them with the mallet.