YTread Logo
YTread Logo

Plunge Cut (Trigger). How to safely cut a heavy leaner.

Apr 14, 2024
here we have a tree that is very leaning, if I make a notch and start from the back, this tree will turn into a barber chair and create a very dangerous situation, so what I'm going to make is a deep cut. Here I'm going to make my notch I'm going to go in through the center and cut back there's two ways I can do it I can dip in here after I make my notch leaving my hinge preset and come back this way and come right out the back or I can get my saw out and then go in this way and release the tree, but I'll have a

trigger

back here that releases the tree, okay, here I want both cuts to come out the same if you cut past that's what Call a Dutchman and that will make the tree more likely to be a barber chair.
plunge cut trigger how to safely cut a heavy leaner
This tree is most likely going to be barbecued first so I want to make sure the two go together perfectly so first I made my top cut which allows me to look through this crack and watch my bar come out of this side and that way this was a little bit I had a little dutch here so I cleaned it up so here we are first I cut this top cut it allows me to see through this crack so when my bar comes out the other side here , which allows me to stop cutting and cut this so that they come out perfectly equal.
plunge cut trigger how to safely cut a heavy leaner

More Interesting Facts About,

plunge cut trigger how to safely cut a heavy leaner...

Now I'm going to go back about ten percent of the diameter of the tree to preset my hinge. Make a hole cut this way, a

plunge

cut, then I'll check that side to make sure it's at 10 and if both sides are good, I'll cut this way through the tree to release the

trigger

. Wow, I finished my

plunge

cut. Now I'm going to cut back to release the trigger. I have an escape route behind me, okay, if you notice, I made my open face cut here, I come this way with my saw, I cut back here and left the trigger, I could have taken the tip of my saw and cut this way, but the tree that was in the way was getting a little difficult, so I decided to cut back and release the trigger that way if I had started this way cutting the cut with that

heavy

tilt, if it started to move when I said here, the tree would have presided over the barber in the center and could have killed me, so it's a really easy way to stay alive.
plunge cut trigger how to safely cut a heavy leaner

If you have any copyright issue, please Contact