Respooling filament for Bambu Lab AMS

Alright, I was going to quickly show how I do rewind. I have some uh jessie uh soul black glitter uh that doesn't fit in the bamboo ams, so I'm going to rewind it. This is a reel seat. I'm using this one I'm using. You can really use any reel seat. This is good. It has a little piece of PTFE here that adds a little resistance so the

filament

doesn't go everywhere if you use a generic one. Reel holder. I would try adding a small piece of PTFE clamped somewhere just so there is a little resistance and the

filament

doesn't fly everywhere.

I have a, I'll wind it on one of the reusable bamboo spools here and then I have this hex bit spool holder and it goes on any old hex bit from a drill and then this drill I like to use this one because it's tilted back a little bit, no There is nothing keeping the reel on, so there is a little resistance. there, but if this was flat, it might come off, so if you notice that happening, just tilt the drill back a little bit, so I'm just going to load it up and secure it and then continue well, I guess I forgot.

To record when I was starting over, I have a piece of PTFE tubing here that I forgot to mention before, plus it adds some resistance, this one you can use if you want to guide your winding if you want it to be clean. or whatever, if you care about that kind of thing and I made a cut in it in case I had to take it off if there's a traffic jam or something, but it's not necessary if everything is going correctly, uh, you don't need a I slipped on it or something like that, so I'll show it here.

I didn't understand the beginning because I forgot to press record and I don't feel like relaxing again, but you know, you can see the general idea. here yes